examples not running?

[fgygi]

The USE_XERCES macro is a leftover from older versions developed at a time when Xerces could not be built on some platforms. I would strongly recommend fixing the linking problem with Xerces. What version of Xerces do you use? What options did you use with the runConfigure script when building Xerces?

[wangfc]

my xerces version is xerces-c-3.0.1
Since this is my first time to use xerces-c
I just make it in the following way:

./configure --prefix=my xerces path
make
and then make install

It was compiled with g++(version 4.1.2). No error message was seen during the process, and it seemed that the xerces-c was installed successfully to where it should be. And also, as I pointed earlier, SAX2Count et al. works well.

Thank you for your advice. I will keep on try to fix my problem with Xerces.

[fgygi]

All the Qbox builds we made so far were using Xerces 2.8.0. Moving to Xerces 3.0.1 is not completely transparent.
See http://xerces.apache.org/xerces-c/migra ... grateto300.
Your best bet at this point to get Qbox running is to install Xerces 2.8.0.

[wangfc]

Thank you very much for the great support.
Everything goes well after I use xerces-c 2.8.0

Thank you very much

[pierrecarrier]

This is a relatively old post, but I encounter the same problem on a Cray machine here (an XE6), I thought you might want to know. I'm installing version qbox-1.56.2 with xerces-c-3.1.1. The flag -DUSE_XERCES give the same error reported before. I also had to use the flag -DXERCESC_3, otherwise I get a syntax error at compile time due to Base64 inside WavefunctionHandler.C.